The Lumatek ballast is a high performance product that is designed to work with most high quality lamps. Cheap inferior lamps may cause problems and Lumatek recommends only high quality American or European lamps. One or two good lamps with very high strike voltages may also be difficult for any electronic ballast to light; Lumatek has an adaptor available for those lamps. For specific recommendations contact your local supplier or Lumatek directly.
Lamp Replacement
Be sure to disconnect the power source before changing lamps. Always use the specified wattage of lamp. (A 400W lamp should not be used in 600W ballast). Lumatek recommends lamp replacement every 6-12 months.
Hot Re-strike
It is VERY important that the lamp is given adequate time to cool down before it is reignited. You should allow a hot lamp to cool for 20-30 minutes before you try to re-strike it. Hot re-strikes causes premature lamp failure and lumen output degradation. Additionally, the lamp should never be turned off before the lamp reaches full intensity.
R.F emissions
Lumatek ballasts are now internally RF shielded and can be used with standard System Cord sets as available in each country worldwide. Our ballasts produce the least amount of EMI (electro- magnetic interference) of any electronic ballast and conform to all international Electro-magnetic emission standards. This applies to all blue and purple models of the Lumatek.
Super-lumen switch
In some territories the latest Lumatek ballast include the industry first “super lumen switch”. This feature will boost lumen output by 10% when the switch is activated. This allows unprecedented control of lumen output during ballast use. This feature is for HPS lamps only. With the switch in position "0" use M.H or H.P.S lamps. With the switch in position "1" use H.P.S only
H.P.S/M.H
Lumatek ballasts operate both metal halide and high pressure sodium lamps. They will not light MV mercury vapor lamps which are commonly sold in hardware and some hydroponics stores. *Please note the 750 watt ballast is HPS only.
Mounting Location
Do not install ballasts in areas of very high heat such as an attic or a closed closet. Do not mount the ballast to the reflector or blow exhaust air over them. Do not stack ballast on top of each other. Do not allow contact with water. Mount units at least six inches apart. If a unit has any leaking resin please relocate to a cooler area or place a fan near the ballasts.
Key Specifications/Special Features:
* Electronic ballast for 600W HPS lamp
* Voltage: 230V 50/60Hz
* Current: 2.70A
* Input power: 620W
* Output power: 600W
* Power factor: >0.99
* Voltage range: 165 to 265V
* THD: <8%
* Lamp CCF: <1.7
* Operating frequency: high frequency
* No audible noise, no flicker
* Environment temperature: -25 to 50°C (-13 to 122°F)
